|
We envision CascAID as a complete sample-to-answer solution for pathogen detection. Apart from our fluorescence detector “Lightbringer”, we hence had to realize a user friendly environment for the extraction and amplification of target RNA from a patient sample via lysis, followed by a combined reverse transcription, isothermal PCR and transcription step.
We therefore conceived a portable fluidic system featuring a temperature control unit and a chip to conduct all said sample processing steps prior to the readout reaction. By combining all steps on a single, enclosed and disposable chip we reduced the risk of cross-contamination and ensured secure handling of reagents and waste products.
Here, we present an early prototype that addresses these criteria. We created the chip from PDMS via soft lithography , using 3D-printed molds to speed up prototyping cycles compared to photolithography-based methods.
As shown in a different section, fluid flow can be controlled with the pressure supplied by air balloons and a bike tire that powers quake valves. In early tests we used an open source 3D printed peristaltic pump, but we expect that the balloon based solution facilitates scaling down the system, improving portability while also lowering the cost.
Buffer Reservoir
The processing buffer, required for isothermal PCR, comes contained on the disposable chip. It is withheld in a reservoir by magnetic valves, held in place by clamps, pierced into the PDMS, which could later be replaced by normally closed quake valves. For reaction rooms and reservoirs we tried to stick to long channels rather than real chambers to prevent the formation of air bubbles.
Sample Uptake
It is convenient to take the patient sample as a swab with absorbent cotton, which can be inserted into a window in the chip that is then closed with a plug. After the chip is connected to the pressure supply, the valves withholding the buffer are opened by removing the clamps. The buffer then flushes the patient sample – including the pathogen – out of the cotton and into the thermolysis chamber.
|
