Team:NTHU Taiwan/Results

Results


     

Achievement


1. We constructed and confirmed all of our composite parts.

2. We proved our recombinant HRP can degrade BPA and NP by the result of mass spectrum.

3. We used IR spectrum to prove the function of our detection method and we took the microscope images on the gold surface to prove the ability to estimate the concentration of EDCs in the water.

4. We found the limitation of our detection method is 5 µM (about 1ppm) of EDCs.

5. Comparison of our detection method and traditional ways:




PART I Degradation




Cloning of Horseradish Peroxidase

To make sure the plasmid is cloned into E. coli BL-21 strain, we extracted the plasmid from transformed E. coli.(Figure 1) We validated the gene by PCR with specific primers and then we examined the result with Agarose gel electrophoresis. A successful cloning was verified from the results of a PCR performed with designed specific primers according to the theoretically expected length of horseradish peroxidase(927bp)(Figure 2).

Figure 1.

Figure 2. Primers for VR backbone:1,3,5 ;primers for HRP:2,4,6




Expression and purification of apo-HRP and refolded-HRP

To obtain functional horseradish peroxidase we need to purify the protein from E. coli, but this kind of protein does not have any function and it is called apoprotein. After the first time purification, we refolded the protein to construct the correct structure and then we activated the apo-HRP with hemin to produce the functional HRP. We examined the existence of this protein by SDS-PAGE after purification. (Figure 3)

Figure 3. SDS-PAGE for purification of HRP




Functional test of Horseradish Peroxidase

We use the mass spectrum to prove HRP can degrade BPA and NP by the signals of the large molecular weight of by-products.(Figure 4-7) We found that there are lots of additional peaks show up after degraded by HRP, and this result can prove our HRP can degrade BPA and NP.

Figure 4. the mass spectrum of BPA

Figure 5. the mass spectrum of BPA after degradation

Figure 6. the mass spectrum of NP

Figure 7. the mass spectrum of NP after degradation




PART II Detection




Cloning of ER-alpha and monobody

We cloned the sequence of ER-alpha and Monobody into the vector, and then we transformed the plasmid into BL-21 competent cells, respectively.(Figure 8 and 9) After transformation, we extracted both plasmids from the cells and the vector was validated by gel electrophoresis.

Figure 8. E. coli with gene of monobody

Figure 9. E. coli with gene of ER-alpha

A successful cloning was verified from the results of a PCR performed with specifically designed primers according to the theoretically expected length of ER-alpha_INP fusion gene (2199bp) and Monobody (797bp).(Figure 10)

Figure 10. 1 : RFP ( mRFP F-primer and mRFP R-primer ); 2 : IPTG (promoter) + INP + RFP2 (ER F-primer and ER R-primer ); 3 : IPTG (promoter) + INP + RFP 1 (ER F-primer and ER R-primer ) ; 4 : IPTG (promoter) + ER with red spot (ER F-primer and ER R-primer ); 5 : IPTG (promoter) + ER2 (ER F-primer and ER R-primer ); 6 : IPTG (promoter) + ER1 (ER F-primer and ER R-primer ); 7 : IPTG (promoter) + Monobody with red spot (Monobody F-primer and Monobody R-primer ); 8 : IPTG (promoter) + Monobody 2 (Monobody F-primer and Monobody R-primer ) ; 9 : IPTG (promoter) + Monobody 1 (Monobody F-primer and Monobody R-primer ); 10 : RFP ( VR primer and VF2 primer ); 11 : IPTG (promoter) + INP + RFP 2 ( VR primer and VF2 primer ); 12 : IPTG (promoter) + INP + RFP 1 ( VR primer and VF2 primer ); 13 : IPTG (promoter) + ER with red spot ( VR primer and VF2 primer ); 14 : IPTG (promoter) + ER2 ( VR primer and VF2 primer ); 15 : IPTG (promoter) + ER1 ( VR primer and VF2 primer ); 16 : IPTG (promoter) + Monobody with red spot ( VR primer and VF2 primer ); 17 : IPTG (promoter) + Monobody 2 ( VR primer and VF2 primer ); 18 : IPTG (promoter) + Monobody 1 ( VR primer and VF2 primer )




Function of ice nucleation protein (INP)

We compared the difference between E. coli expressed RFP and RFP-INP(Figure 11). After the lysis of culture expressing RFP-INP, most of RFP was on the fragments of the membrane. Due to the larger structure of plasma membrane, it is easily spin down. If RFP-INP is on the E. coli plasma membrane when we centrifuged the cell lysate, RFP-INP is spun down with the plasma membrane, and we see a red pellet.

On contract, after cell lysis of RFP expression E. coli, most of RFP suspended in the solution. Since the centrifugation force, we set in this experiment is not enough to spin down particles as small as RFP. We see RFP suspended in the supernatant even after centrifugation.

This experiment showed that INP can bring RFP to the membrane of E. coli, and this result proved the function of INP.

Figure 11. 1 : Fragments of E. coli with gene of RFP-INP ; 2: Fragments of E. coli with gene of RFP




Characterization of biosensing chip

To prove that our biosensing chip can distinguish the sample has EDCs or not, we used IR spectrum to measure specific bonds on E. coli and verify the detection function.(Table 1)

Table 1. The IR signals for E. coli

In the beginning, we try to use live cells for the biosensing chip. However, we found that all the samples have the information of E. coli. Showing that there is no difference between the sample with 5mM EDCs and the sample with no EDCs. (Figure 12)

Figure 12. The IR spectrum of samples in different conditions (live E. coli)

To decrease the activity of E. coli, we tried to freeze E. coli in -80℃ for 24 hours and use it after thawing on ice immediately. We found that there is a significant difference between the sample with 5mM EDCs and EDCs-free and the intensity of IR signals also decrease due to the reduction of mobility of E. coli.(Figure 13) This result can prove that our biosensing chip can detect EDCs in the water.

Figure 13. The IR spectrum of samples in different conditions (freezed E. coli)




Proof of concept: quantifying a number of EDCs in the water

To prove our biosensing chip can measure the concentration of EDCs, we use crystal violet to stain E. coli on the surface of gold and then observe the density of stained E. coli under microscope. Due to the surface tension force of water, there are lots of E. coli remained around the drop edge of sample, and we only observed the area in the middle of the sample to reduce the error. (Figure 14)

Figure 14. The sample under 50X microscope

We observed the density of E. coli when the samples contained a different concentration of BPA and NP from 5mM to 5nM (Figure 15 and 16). This result indicates that when the concentration of EDCs decreases, the density of E. coli will decrease as well.

Figure 15. The samples with different concentration of BPA under 500X microscope

Figure 16. The samples with different concentration of NP under 500X microscope

For the practical propose, we added trehalose (0.1M) to prevent ER-alpha from denaturing and increase the time of conservation. We also observed the density of E. coli with samples containing the different concentration of BPA and NP from 5mM to 5nM.(Figure 17 and 18) From the result of observation, we can find the similar tendency as the sample without trehalose.

Figure 17. The samples with different concentration of BPA in 0.1M trehalose under 500X microscope

Figure 18. the samples with different concentration of NP in 0.1M trehalose under 500X microscope

To clarify the relationship between the concentration of EDCs and the density of E. coli, we use image J to count the amount of E. coli on the surface. (Figure 19-22) From the results of imageJ, we can get the similar tendency as the result from the pictures of the microscope. However, the density of E. coli decreases in the presence of 0.1 M trehalose, and this result suggested that although trehalose can improve the time to store lyophilized E. coli, it can decrease the precision of our biosensing chip.

Figure 19. Samples of BPA

Figure 20. Samples of NP

Figure 21. Samples of BPA in 0.1M trehalose

Figure 22. Samples of NP in 0.1M trehalose




Functional test of ER-alpha

To ensure the function of ER-alpha on the surface of E. coli, we compared the difference between the BL-21 E. coli and ER-alpha expressed E. coli in the different concentration of BPA and NP. (Figure 23 and 24)From the results, we found that BL-21 can’t affect the outcomes of the biosensing chip beyond 5µM of EDCs.

Figure 23. Samples of BPA

Figure 24. Sample of NP




The limitation of our biosensing chip

To further understand the limitation of the concentration that our biosensing chip can achieve, we observed the density of E. coli in four different conditions of background. We find that when there are no EDCs in the sample, the density of E. coli is close to the concentration of EDCs below 5µM. Showing that our biosensing chip can’t measure the concentration of EDCs less than 5µM.(Figure 25 and Table 2)

Figure 25. The background of 4 different conditions

Table 2. The amounts of E. coli in the 4 different backgrounds




Part III Future Work

1. Since we failed to express GFP and ER-alpha at the same time, we will try to construct the gene containing GFP and ER-alpha and express them together for the purpose of detection. (Figure 26)

Figure 26. Expression of GFP in the E. coli for detection.

2. Since we don’t have time to construct the biosensing chip to measure the change of fluorescence, we will construct the biosensing chip to estimate the concentration of EDCs in the water precisely. (Figure 27)

Figure 27. Using the change of fluorescence to estimate the precise concentration of EDCs in the water




Reference



1. Dong, S., Mao, L., Luo, S., Zhou, L., Feng, Y., & Gao, S. (2014). Comparison of lignin peroxidase and horseradish peroxidase for catalyzing the removal of nonylphenol from the water. Environmental Science and Pollution Research, 21(3), 2358-2366.

2. Tamerler, C., Oren, E. E., Duman, M., Venkatasubramanian, E., & Sarikaya, M. (2006). Adsorption kinetics of an engineered gold binding peptide by surface plasmon resonance spectroscopy and a quartz crystal microbalance. Langmuir, 22(18), 7712-7718.

3. Vineh, M. B., Saboury, A. A., Poostchi, A. A., Rashidi, A. M., & Parivar, K. (2017). Stability and activity improvement of horseradish peroxidase by covalent immobilization on functionalized reduced graphene oxide and biodegradation of high phenol concentration. International Journal of Biological Macromolecules.

4. Gundinger, T., & Spadiut, O. (2017). A comparative approach to recombinantly produce the plant enzyme horseradish peroxidase in Escherichia coli. Journal of Biotechnology, 248, 15-24.

5. Filip, Z. D. E. N. E. K., Hermann, S., & Demnerova, K. A. T. E. Ř. I. N. A. (2008). FT-IR spectroscopic characteristics of differently cultivated Escherichia coli. Czech Journal of Food Sciences-UZPI (Czech Republic).

6. Furst, A. L., Hoepker, A. C., & Francis, M. B. (2017). Quantifying Hormone Disruptors with an Engineered Bacterial Biosensor. ACS central science, 3(2), 110-116.