Difference between revisions of "Team:Uppsala/Notebook"

Week: 10/07-14/07/h3>

- Low copy plasmids transformed last week were re-streaked. Colony PCR followed by Gel electrophoresis was done on them.
- Positive colonies, screened from colony PCR were re-streaked and glycerol stock was made for them.
- Electroporation-competent DH5α cells were prepared.
- The PCR amplified constructs were restricted digested and ligated to high copy plasmid backbones cells. These plasmids were then transformed by heat-shock.
- More low copy plasmid for each antibiotics with Red fluorescent protein RFP were purified from the master stock.
- UGTCs2 gene was cloned in pSB1C3 plasmid backbone since using tetracyclin was being troublesome.
- Electro-competent cells were tested with cloned genes. No growth was observed. Possible cause: cells died during electroporation. Desalt the ligated DNA.
- Colony PCR of the positive colonies (white colonies) obtained from heat shock transformation of cloned genes in high copy plasmids. No bands visible..

Lambda red integration:

- Tested transduction with bgl strain as the donor and MG1655 as receiver (Cat-SacB will be transduced). 1 colony was found on the plate with chloramphenicol. This one was restreaked on chloramphenicol which then had more growth.
- Tried to insert CrtI gene in IS150 strain and dhfr gene in gsp strain using lambda red. The IS150 strain grew on sucrose (indicating that the SacB sequence had been replaced) but tetracycline had not been added so the strain could have lost the lambda red plasmid. The gsp strain had strange growth pattern.

Week: 17/07-21/07

- Fresh start of Restriction digestion and Ligation of PCR amplified constructs into high copy plasmids. Used both Heat shock (with commercial competent cells) and Electroporation.
- Positive (white) colonies were restreaked and colony PCR was done. No bands were observed.
- Troubleshooting of colony PCR. Optimised PCR parameters and new buffer components.
- SDS-PAGE parameters were optimised and a test run was done with BSA dilutions. No bands were observed in the first run due to improper buffer. Troubleshoot and Run again!

Lambda red integration:

- PCR of inserts CrtI, dhfr, CrtZY and CrtEB. Gel elecrophoresis for verification (see figure below).
- PCR of inserts CrtZY and CrtEB. Gel electrophoresis for verification but there was nothing on gel Purification of inserts CrtI and dhfr.
- Gel electrophoresis of pooled PCR products of insert CrtEB and CrtZY from 17/7 (see figure below). Electroporation of purified CrtI gene in IS150 strain and purified dhfr gene in gsp strain. Put overnight on shaking water bath.
- The overnight cultures of IS150 strain was streaked on tetracycline and sucrose plates and gsp strain was streaked on tetracycline and trimetoprim plates. Gel electrophoresis of CrtEB insert (see figure below).

Week: 24/07-28/07

- Positive colonies carrying construct in tetracycline backbone from last week were re-streaked to check for viability.
- Buffers for immobilised metal affinity chromatography (IMAC) were prepared and degassed. IMAC column was packed.
- Positive cells (white colonies) from containing genes in high copy plasmids were grown overnight and sonicated. The lysates were purified by IMAC.
- More LB agar plates with antibiotics were prepared.

Lambda red integration:

- PCR of insert CrtEB. Restreak clones of IS150 strain from 21/7 on sucrose and tetracycline plates and gsp strain from 21/7 on and tetracycline and trimetoprim plates. Liquid cultures with same respective antibiotics for the strains were made.
- Gel electrophoresis of CrtEB PCR product from 24/7. Restreak colonies of IS150 strain from 24/7 plates on sucrose plates then chloramphenicol plates. Prepare cultures for transduction of IS150 by growing overnight in P1 LB. Purify CrtZY and CrtEB and use nano drop on all purified inserts to check DNA concentration. Ordered new primers for CrtEB.

- gsp strain did not grow on plates but did in liquid culture. 5 of 8 colonies of IS150 strain from 25/7 grew on sucrose but not chloramphenicol. New plates were made (tet + chlor, tet + tmp, tet + suc, chlor). Transduction of bgl strain as the donor and IS150 as receiver. Take some gsp liquid culture and put in some tet + sucrose to make sure it’s our strain that’s growing. Make liquid cultures with gsp (dhfr) in tet + tmp with the different tet to check if antibiotics work.
- No growth on transducer IS150 from 26/7. Start overnight culture of bgl strain to make lysate (donor strain). Colony PCR of the colonies from 26/7 that grew on sucrose but not on chlor and gel electrophoresis to check inserts. Make tet + chlor and tet + tmp plates. Start overnight cultures of IS150 strains with inserts that were confirmed by colony PCR.
- Colony PCR of gsp strain and gel electrophoresis

Week: 31/07-4/08

- To confirm the presence of genes in the colonies, Screening was performed by restriction digestion and electrophoresis.
- Troubleshooting of Colony PCR was done with commercial Taq polymerase master mix.
- Biobrick from 2010 Slovenia Team containing 5 enzymes crtEBIYZ was transformed to E.coli by heat shock.
- Fresh batches of 3 selected positive colonies (one for each enzyme) were grown overnight in TB and lysed for sonication. Lysates were purified by IMAC.
- Eluted fractions were subjected to SDS-PAGE.
- The three colonies with recombinant plasmids were grown and plasmid prep was done. Restriction digestion and gel electrophoresis was done for screening.
- Fresh, presumably positive colonies (white colonies) were selected from master plates and re-streaked. Colony PCR was done for them followed by electrophoresis
- Gel chromatography and SDS was done for IMAC purified elutes.
- A second round of screening by digestion was done with modifications as the plasmids and the construct were of similar size therefore needed better resolution.
- Making all the constructs in pSB1C3 for biobrick submission.

Lambda red integration:

- Start overnight culture of bgl with chlor for lysate.
- Make lysate for transduction with bgl strain as donor. Start overnight culture of gsp strain (to make competent the next day) and one of the colonies from 27/7 of the IS150 strain that had CrtI insert (to have as receiver for transduction next day).
- Finish lysate with bgl strain as donor. Make competent cells of gsp strain. Transduction of bgl strain as the donor and IS150 (prepared 1/8) as receiver and streak on tet+chlor plates.
- No colonies on transduced plates from 2/8. Electroporation of dhfr insert in gsp strain.

Week: 7/08 - 11/08

Lambda red integration:

- PCR of CrtEB insert. Buffer/media preparation. Redo transduction from 2/8 and electroporation from 3/8. Start overnight culture of bgl with chlor for lysate and IS150 strain that had CrtI insert (to have as receiver for transduction next day).
- Gel electrophoresis of CrtEB PCR product from 8/8 (see figure 8). Make lysate for transduction with bgl strain as donor (in 30°C and 37°C). Transduction of bgl strain (lysate made 2/8) as the donor and IS150 (prepared 8/8). Start overnight culture of the IS150 (to have as receiver for transduction next day).
- No colonies on transduced plates from 9/8. Make plates and SOB. Finish lysate (30°C and 37°C) from 9/8. Purify CrtEB from PCR 9/8. Electroporation of dhfr insert in gsp strain and CrtZY in gsp strain. Transduction of bgl strain (lysate made same day) as the donor and IS150 (prepared 9/8).
- No colonies on transduced plates from 10/8. Streak electroporated gsp strains from 10/8 on tet+tmp+chlor plates for strain with dhfr and tet+suc plates for CrtZY).

Week: 14/8 - 18/8

Lambda red integration:

- Electroporation of CrtEB insert in IS150 strain and CrtZY in gsp strain. Start overnight culture of gsp with CrtZY + dhfr and IS150 with CrtI + CrtEB.
- Make lysate for transduction with gsp strain as donor. Transduction of bgl strain (lysate made same day) as the donor and IS150 (prepared 14/8).
- No colonies on transduced plates from 15/8.

Week: 21/8 - 27/8

Lambda red integration:

- P1 transduction of bgl::cat-sacB into the IS150::CP25-crtI strains + wt control + cam control
Incubate 30 minutes in 37°C
Plate crtI recipients on cam+tet, incubate in 30°C
One control on only cam, 30°C
Plate wt control on cam, incubate in 30°C
Run screening PCR of IS150::crtI and gsp::crtYZ strains
- Gel analyze crtI and crtYZ screening - all clones correct size!
Purify PCR products crtI and crtYZ
Check transduction plates - the transduction worked well, more than 100 colonies per plate.

- Run screening PCR of IS150::crtI and gsp::crtYZ strains
Gel analyze PCR products
crtI screening (4 wells) - weak bands
crtYZ screening (3 wells) - good bands
Start overnight cultures crtI + bgl::csb
- Purify PCR products
Send for sequencing
crtI - use IS150_seq_2, crtI_scr_1 and crtI_scr2 (IS150_scr_R)
crtYZ - use crtZY_scr_1,crtZY_scr_2 and gsp_scr_R (gsp_ins_R)
Freeze crtI + bgl::catsacB strains + streak them on plate and leave in RT over the weekend

Week: 28/8 - 3/9

- Ordered more UGTCs2 from IDT
- linearised iGEM plasmid psB1C3-J04500 using Phusion PCR and transformed CsADH2946 construct into the plasmid using Gibson assembly.
- Transformed into commercial competent TOP10 E. coli cells.

Lambda red integration:

- Sequencing results showed that the clones are correct.
Streak up from -80°C
Eco gsp::crtZY /pSIM5-tet clone 1

- Start overnight cultures of crtI and crtZY strains (Salt free LB + tet, 30°C)
Eco gsp::crtZY /pSIM5-tet clone 1
Eco IS150::crtI bgl::cat-sacB /pSIM5-tet
- Lambda Red
Eco IS150::crtI bgl::cat-sacB /pSIM5-tet
+ crtEB (PCR product)
Eco gsp::crtZY /pSIM5-tet
+ gspC::dhfr (PCR product)
- Plate cells Lambda Red
Eco IS150::crtI bgl::cat-sacB /pSIM5-tet + crtEB
Plate on sucrose + tet
Eco gsp::crtZY /pSIM5-tet + gspC::dhfr
Plate on tmp
- Restreak transductants Lambda Red - leave in RT over the weekend
Eco IS150::crtI bgl::cat-sacB /pSIM5-tet + crtEB
Plate on sucrose + tet
Eco gsp::crtZY /pSIM5-tet + gspC::dhfr
Plate on tmp
-
-

Week: 4/9 - 10/9

- Colony PCR and ran gel electrophoresis for validation of insertion. Sent for sequencing.
- Transformed BL21(DE3)* with sequence verified CsADH2946 plasmid. Large scale expression and cell harvest.

Lambda red integration:

- Start overnight cultures of Lambda Red transformants
Eco IS150::crtI bgl::crtEB /pSIM5-tet
Grow in LB + tet in 30°C (1.5 ml, will also use for transduction)
Eco gsp::crtZY gspC::dhfr
Grow in LB + tmp in 37°C (1.5 ml, will also use for P1 lysate)
- Make P1 lysate (put in fridge after lysis)
Eco gsp::crtZY gspC::dhfr
Freeze overnight cultures of Lambda Red transformants
Eco IS150::crtI bgl::crtEB /pSIM5-tet
Eco gsp::crtZY gspC::dhfr

-
-
-

-
-
-