Construction: On top of a ~10x10x0 cm aluminium block thermal compounds was added and a Peltier element sticked to it. The warm side was facing away from the block. The silicone tubing coming from the peristaltic pump that was attached to the main reactor bottle was curled a couple of times and glued to the Peltier element. A hole was drilled into a styrofoam block that approximately had the same lengths as the aluminium block. Inside that hole a temperature sensor (DS18B20 digital temperature sensor) was placed and wired to a “Raspberry pi 3” (Rpi). This way it was possible to monitor the “heat shock” process.This block was placed over the tubing and fixed to the aluminium block. To control the Peltier element a relay module was also connected to the same RPi. Electricity was taken from a variable power adapter.